New Pool Startup After Builder Handover: Brushing, pH Rise and Curing Dust

New Pool Startup After Builder Handover: Brushing, pH Rise and Curing Dust

Builder handover usually starts the owner’s startup phase — it does not end it A…

01.04.2026
Autofill or Top-Up Valve Stuck Open: Why Salt and CYA Keep Dropping

Autofill or Top-Up Valve Stuck Open: Why Salt and CYA Keep Dropping

Chemistry and equipment diagnosis When salt and CYA keep drifting down, owners often assume the…

31.03.2026
Pool Pump Mechanical Seal Leak: The Drip Between Motor and Wet End

Pool Pump Mechanical Seal Leak: The Drip Between Motor and Wet End

A drip in the center of the pump is not the same as a lid…

30.03.2026
Breaker or RCD Trips When Pool Equipment Starts: Safe First Checks

Breaker or RCD Trips When Pool Equipment Starts: Safe First Checks

When pool equipment trips power at startup, the safest approach is to identify the trigger…

27.03.2026
Pool Light Condensation or Water Inside? How to Tell if It’s a Seal, Bulb or Conduit Leak

Pool Light Condensation or Water Inside? How to Tell if It’s a Seal, Bulb or Conduit Leak

Pool light moisture is a diagnosis problem first, not a bulb-shopping problem A fogged pool…

27.03.2026
Pool Cover Roller Problems: Sagging, Dragging and Wind Damage

Pool Cover Roller Problems: Sagging, Dragging and Wind Damage

Most roller damage starts with poor fit, weak support or bad handling — not with…

26.03.2026
Solar Blanket Bubble Side Up or Down? Best Daily Routine for Melbourne Pools

Solar Blanket Bubble Side Up or Down? Best Daily Routine for Melbourne Pools

Pool solar blanket use and care for Melbourne conditions Which side faces the water? The…

26.03.2026
Heat Pump Placement Mistakes: Clearance, Airflow and Noise Around the Pool

Heat Pump Placement Mistakes: Clearance, Airflow and Noise Around the Pool

Bad placement usually shows up as weak performance, nuisance noise, or a site that becomes…

25.03.2026
Heat Pump Defrost Cycle or Fault? How to Tell in Cool Weather

Heat Pump Defrost Cycle or Fault? How to Tell in Cool Weather

Cool-weather heat pumps can look worse than they actually are In winter and shoulder season,…

25.03.2026
Salt Cell Cable and Terminal Corrosion: Hidden Cause of Low Output

Salt Cell Cable and Terminal Corrosion: Hidden Cause of Low Output

Low output can start at the connector, not inside the cell A salt chlorinator can…

24.03.2026
Call Now Button